Privacy settings | Privacy/Cookies | About our Ads | Legal Notices & Trademarks | Report Noncompliance | Site map | © 2018 Autodesk Inc. All rights reserved
Customize your EAGLE software with community-created programs.
This EAGLE User Language Program generates a Script file that can be used to renumber the parts of a board (then schematic) in respect of the values found. ie : R1,R2,..., Rn : same value \r\nUploaded by Laurent AUTHIER TABANON from FRANCE
Updated to support every possible grid-unit you like to use (mic, mm, mil, inch).\r\nUploaded by Rene Koenig
Copy Signal-Wire and/or Polygon to Stop-Layer\r\nUploaded by A. Zaffran from CadSoft
I modified the export project ULP to allow exporting all parts into a single project specific library. BUT, the magic part is that it also generates a script you can run afterward to replace all parts in the schematic so they reference the newly created project specific library. I\'ve also updated the ULP so it now shows a list of all libraries used in a schematic and it allows selecting which library parts to export/replace. Now you can easily export and edit any of the parts in any of your designs within a single project specific library on the fly!
Generates manual placement guide circles, draws circles around selected components.\r\nUploaded by Jonas Qvarnström from Bergsäker AB
ULP to help snapping schematic elements back to the grid\r\nUploaded by Andreas Schulz from at home
Change and swap (copper) layer. Version 4.1\r\nUploaded by A. Zaffran from CadSoft
Renumbers parts on a board. Each part type will start with a numerical extension of \\\"1\\\". Useful after deleting parts, to close \\\"numerical holes\\\".\r\nUploaded by Frank Hübenthal from InnoSys GmbH
Creates a script file which adds offset via\"s and traces to BGA\"s on a board.\r\nUploaded by Jim Thurman from NeuroCom Intl
Duplicate your modules (both sch+brd) very easily, just place markers around blocs, give value to NBR_MOD, and type CTRL+D!!! \r\nUploaded by Maurice SAAB from SEC-Lebanon