Privacy settings | Privacy/Cookies | About our Ads | Legal Notices & Trademarks | Report Noncompliance | Site map | © 2018 Autodesk Inc. All rights reserved
Customize your EAGLE software with community-created programs.
Version for Eagle 4.11. This ULP exports board or schematic to Color EPS. Program is based on epsdraw.ulp. Edit EPS file (or this ULP) to change color of printed layers in EPS.\r\nUploaded by Filip Kinovic from ICHT Prague, CZ
Duplicate your modules (both sch+brd) very easily, just place markers around blocs, give value to NBR_MOD, and type CTRL+D!!! \r\nUploaded by Maurice SAAB from SEC-Lebanon
Creates a script file which adds offset via\"s and traces to BGA\"s on a board.\r\nUploaded by Jim Thurman from NeuroCom Intl
Renumbers parts on a board. Each part type will start with a numerical extension of \\\"1\\\". Useful after deleting parts, to close \\\"numerical holes\\\".\r\nUploaded by Frank Hübenthal from InnoSys GmbH
Change and swap (copper) layer. Version 4.1\r\nUploaded by A. Zaffran from CadSoft
ULP to help snapping schematic elements back to the grid\r\nUploaded by Andreas Schulz from at home
Generates manual placement guide circles, draws circles around selected components.\r\nUploaded by Jonas Qvarnström from Bergsäker AB
I modified the export project ULP to allow exporting all parts into a single project specific library. BUT, the magic part is that it also generates a script you can run afterward to replace all parts in the schematic so they reference the newly created project specific library. I\'ve also updated the ULP so it now shows a list of all libraries used in a schematic and it allows selecting which library parts to export/replace. Now you can easily export and edit any of the parts in any of your designs within a single project specific library on the fly!
Copy Signal-Wire and/or Polygon to Stop-Layer\r\nUploaded by A. Zaffran from CadSoft
Updated to support every possible grid-unit you like to use (mic, mm, mil, inch).\r\nUploaded by Rene Koenig