Privacy settings | Privacy/Cookies | About our Ads | Legal Notices & Trademarks | Report Noncompliance | Site map | © 2018 Autodesk Inc. All rights reserved
Customize your EAGLE software with community-created programs.
Offers a selection to open (one of) the respective Library Editor window(s) of the currently edited DEVice/PACkage/SYMbol. It is also possible to edit a DEVice, PACkage, or SYMbol from Schematic or Board directly.\r\nUploaded by A. Zaffran from CadSoft
Exports the board to HyperLynx Signal-Integrity Transfer Format (.HYP) W.curve correction in C.element.package.wires(W) for Eagle 4.1 Corrected PADSTACK counter in used PADSTACK \r\nUploaded by A,. Zaffran from CadSoft
Run this ULP on a schematic. It makes a simple text file in the project directory that cross references all parts to the sheet they are on.\r\nUploaded by Kevin Callan from St. Louis
This ULP can be used to automate filling out a frames docfield.Dieses ULP kann verwendet werden, um das Docfield eines Rahmens automatisiert auszufüllen.\r\nUploaded by René König
This ULP generates a figure-file (*.pic) from the schematic drawing for using within LaTeX. Used packages: epic and eepic.\r\nUploaded by Matthias Haselberger from Carinthian Tech Institute
Make Schematic - > Board consistent. Use the VALUE from Schematic.\r\nUploaded by A. Zaffran from CadSoft
simple script to zoom to the first unrouted wire in board editor. this might be helpful when searching for tiny left- overs in the end phase of routing work.\r\nUploaded by Daniel Mack from caiaq
WIRELIST.ulp produces an optimum length, \\\"wire run\\\" SIGNAL List/Script File, for wire-wrapping or soldering proto and project boards. The resulting SCR can be executed to reroute a duplicate board layout into the equivalent \\\"wired version\\\". See instructions in ULP header. \r\nUploaded by Joseph Zeglinski from None
Ever needed to limit your board\"s drills to a standard drill rack to avoid costs? Eagle does not allow you to change pad drill sizes outside the library - neither does this ULP. BUT at least it lists which part from which library causes the non-standard drill to be listed by drillcfg.ulp. It also counts drills in total and per size. Based on CadSoft\"s drillcfg.ulp. Revision 2 with bugfix.\r\nUploaded by Philipp Adelt from http://philipp.adelt.net
Modified netlist ULP to include x,y locations of pads, useful for making automatic pcb testing fixtures. This version additionally informs about the location of vias. For EAGLE 3.5 and higher.\r\nUploaded by Richard Hammerl from CadSoft Computer GmbH