Privacy settings | Privacy/Cookies | About our Ads | Legal Notices & Trademarks | Report Noncompliance | Site map | © 2018 Autodesk Inc. All rights reserved
Learn how to use EAGLE from a variety of example projects.
Arduino Uno Revision 3 1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Arduino Due that operate with 3.3V. The second one is a not connected pin, that is reserved for future purposes. Stronger RESET circuit. Atmega 16U2 replace the 8U2.
Einstellbarer Spannungsregler 0-30V 1,5A mit LM 317\r\nUploaded by Dirk Bendig
A small 2W Bridged Channel audio amplifier using TDA2822 IC. Including volume control. 12V PSU is Ideal. No heatsink required for IC. By default, the design only displays the bare circuit in \"board view\", so just enable the necessary layers for component values and pinouts.\r\nUploaded by Bradlin Basson from South Africa
Adapter von DB-25 auf Klemmenleiste und durchgeschliffen auf Pfostenstecker f
Fine Adjustment for the travel of a sailwinch (radio controlled model) or other type of servo. \r\nUploaded by Clozeau Olivier from France
Lattice Semicondutor Evaluation Boards for isp1016, 2032, ispGDS14 and Daisy Chain Programming Cable Board \r\nUploaded by Arto Kyyhkynen from Helsinki Finland
Fertiges Board zum Test der Funktion des Ultra DMA Standarts von Controller- Chips
this is an active filter, high pass filter, economical with only one op amp.cutt-off freq = 350 Hz. you have here the circuit itself, has been scanned.\r\nUploaded by bogdan rusu from S.C.Axel Telecom Cluj S.R.L. - ROMANIA